Visual Inspection
WARNING: This page is about a different variant/trim than selected.
NOTE:
- Before performing the following inspection, make sure to follow the procedure as indicated in the troubleshooting flowchart. (See HOW TO USE THIS MANUAL .)
- Visually inspect for the following on the MAF sensor. (See
INTAKE AIR SYSTEM REMOVAL/INSTALLATION
.)
- Damage
- Cracks
- Bent terminals
- Terminal rust
- If any of the above are found, replace the MAF/IAT sensor.
- If the monitor item status/specification (reference) is not within the specification even though there is no malfunction, perform the "CIRCUIT OPEN/SHORT INSPECTION ".