LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mazda >> 2005 >> 3 SP23, 4D Hatchback, Standard >> Repair and Diagnosis >> Engine Performance >> System >> On-Board Diagnostic [Engine Control System] >> DTC P2089 >> Diagnostic procedure
October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.

Diagnostic procedure

DTC P2089 DIAGNOSTIC PROCEDURE

STEP INSPECTION ACTION
1 VERIFY FREEZE FRAME DATA HAS BEEN RECORDED 
  • Has FREEZE FRAME DATA been recorded?
 Yes Go to the next step.
No Record the FREEZE FRAME DATA on the repair order, then go to the next step.
2 VERIFY RELATED REPAIR INFORMATION AVAILABILITY 
  • Verify related Technical Service Bulletin(s) repair information availability.
  • Is any related repair information available?
 Yes Perform repair or diagnosis according to the available repair information.
  • If the vehicle is not repaired, go to the next step.
No Go to the next step.
3 INSPECT OCV CONNECTOR FOR POOR CONNECTION 
  • Turn the ignition switch off.
  • Inspect for poor connection (such as damaged, pulled-out pins, corrosion).
  • Is there any malfunction?
 Yes Repair or replace the terminal, then go to Step 7.
No Go to the next step.
4 INSPECT OCV  Yes Go to the next step.
No Replace the OCV, then go to Step 7.
5 INSPECT PCM CONNECTOR FOR POOR CONNECTION 
  • Turn the ignition switch off.
  • Disconnect the PCM connector.
  • Inspect for poor connection at PCM terminal 2AF (such as damaged, pulled-out pins, corrosion).
  • Is there malfunction?
 Yes Repair the terminal, then go to Step 7.
No Go to the next step.
6 INSPECT OCV CONTROL CIRCUIT FOR SHORT TO POWER 
  • Remove the OCV.
  • Turn the ignition switch to the ON position (Engine off).
  • Measure the voltage between PCM terminal 2AF and body ground.
  • Is the voltage B+  ?
 Yes Repair or replace the wiring harness for short to power circuit, then go to the next step.
No Go to the next step.
7 VERIFY TROUBLESHOOTING OF DTC P2089 COMPLETED 
  • Make sure to reconnect all disconnected connectors.
  • Clear the DTC from the PCM memory using the WDS or equivalent.
  • Turn the ignition switch off.
  • Start the engine and warm it up completely.
  • Is the same DTC present?
 Yes Replace the PCM, then go to the next step.
(See PCM REMOVAL/INSTALLATION .)
No Go to the next step.
8 VERIFY AFTER REPAIR PROCEDURE  Yes Go to the applicable DTC inspection.
(See DTC TABLE )
No Troubleshooting completed.
scientia non olet · About LEMON Manuals