Service Cautions: Reassembly

Standard values, such as torques and certain adjustments, must be strictly observed in the reassembly of all parts.
If removed, these parts should be replaced with new ones:
- Oil seals
- Gaskets
- O-rings
- Lock washers
- Cotter pins
- Nylon nuts
  
  Fig 1: Tightening Parts With Specified Values
  Courtesy of MAZDA MOTORS CORP.
Depending on location:
Sealant and gaskets, or both, should be applied to specified locations. When sealant is applied, parts should be installed before sealant hardens to prevent leakage.
- Oil should be applied to the moving components of parts.
- Specified oil or grease should be applied at the prescribed locations (such as oil seals) before reassembly.
  
  Fig 2: Proper Application Of Sealant On Joints & Mating Surfaces
  Courtesy of MAZDA MOTORS CORP.