Pats Initiations
NOTE:
This procedure must be performed every time a PATS module is replaced. If PATS module is from another vehicle, keys must also be programmed. See KEY PROGRAMMING (WITH PROGRAMMED KEYS)
.
Install new PATS module. See PATS MODULE under REMOVAL & INSTALLATION. With NGS tester connected to vehicle, enter function test menu. Select SECURITY ACCESS PROCEDURE. This procedure will take 10 minutes to perform. After security access procedure is completed, select PARAMETER RESET. Turn ignition switch to OFF position. Disconnect NGS tester from vehicle. Cycle first key in ignition to ON position, then cycle second key in ignition to ON position. Program additional keys as necessary. See KEY PROGRAMMING (WITH PROGRAMMED KEYS) .