SAS Unit

WARNING:
^ Handling the SAS unit improperly can accidently deploy the air bag modules which may cause serious injury. Read AIR BAG SYSTEM SERVICE WARNINGS before handling the SAS unit.




1. Turn the ignition switch to LOCK.
2. Disconnect the negative battery cable and wait for more than 1 minute to allow the backup power supply of the SAS unit to deplete its stored power.
3. Remove the rear console.
4. Remove the side wall.
5. Remove in the order indicated in the table.
6. Install in the reverse order of removal.
7. Turn the ignition switch to ON.
8. Verify that the air bag system warning light illuminates for approximately 6 seconds then goes off.
9. If the air bag system warning light remains on, remains off, or continuously flashes after service, there are malfunctions in the system. Repeat the inspection again. (Refer to AIR BAG SYSTEM ON-BOARD DIAGNOSIS.)




Nut Installation Note
^ Tighten the nuts in the order shown in the figure.