Crankshaft Position (CKP) Sensor Removal/Installation
WARNING: This page is about a different car, the 2005 Mazda MX-5 Miata. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect the CKP sensor connector.
- Remove the undercover.
- Remove the CKP sensor installation bolt.
- Install in the reverse order of removal.
Tightening torque
- 7.9-10.7 N.m {80-110 kgf.cm, 69.5-95.4 in.lbf}
- Reconnect the CKP sensor connector.NOTE:
- Do not forcefully pull the wiring harness of the CKP sensor.
- Adjust the air gap. (See CRANKSHAFT POSITION (CKP) SENSOR ADJUSTMENT .)