Switch Monitor Function, Inspection Procedure

SWITCH TEST DIAGRAM




SWITCH MONITOR FUNCTION TEST CHART

Inspection Procedure




1. Connect the SSTs (Special Service Tool) to the data link connector as shown.
2. Turn the ignition switch to ON.
3. Set conditions to deactivate all switches and verify that the monitor light does not illuminate. If any switch remains activated, the monitor light will be illuminated.
4. Check if the monitor light illuminates when each switch is made to function as described below.
5. If the monitor light will not illuminate at some switch, check the switch and related wire harness and repair or replace as necessary.




MONITOR LIGHT TEST PROCEDURES