Manual Trans.

INSPECTION
1. Remove the distributor.
2. Disconnect the fuel injector connector.
3. Verify that the distributor connector (4-pin) is disconnected.
4. Connect the distributor connector (6-pin).
5. Disconnect the fuel injector connector.
6. Turn the ignition switch ON.




7. Connect the SSTs (Engine Signal Monitor and Adapter Harness) to the ECM as shown.
8. Set the SST (Engine Signal Monitor).




9. Rotate the distributor drive by hand and measure the output voltage.




Specification
Signal Terminal Voltage
SGT 2E Approx. 5V (4 pulses/rev)
SGC 2G Approx. 5V (I pulse/rev)




10. After the inspection, install the distributor.
11. Start the engine and adjust the ignition timing.

Ignition timing: BTDC 11-13° (12 ± 1°)

12. Tighten the distributor lock bolts to the specified torque.

Tightening torque:
19-25 N-m (14-18 ft-lb)