LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mazda >> 1994 >> Protege Base >> Repair and Diagnosis >> Transmission >> Clutches >> Removal & Installation >> Clutch Assembly >> Installation
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Clutch Assembly: Installation

  1. Install new pilot bearing flush with end of crankshaft.
  2. Ensure all bolts are clean and free of old sealant. Coat bolt threads with Stud and Bearing Mount Sealer (EOAZ-19554-B ). Install and tighten bolts to specification in a crisscross pattern. See TORQUE SPECIFICATIONS  .
  3. Position clutch disc onto flywheel, with damper springs facing outward. Retain disc in place with clutch aligner. Position pressure plate over clutch disc and align marks made at removal (if reusing pressure plate).
  4. Install and tighten bolts to specification in a crisscross pattern. See TORQUE SPECIFICATIONS  . Remove clutch aligner. Lightly coat input shaft splines with White lithium grease.
  5. Install transaxle assembly by aligning input shaft through clutch disc splines. Align clutch housing onto engine guide pins. Install and tighten clutch housing bolts to specification. See TORQUE SPECIFICATIONS  . To complete installation, reverse removal procedure.
scientia non olet · About LEMON Manuals