All Functions Of Driver Seat Inoperative
- Measure voltage at Blue wire terminal of control switch 14-pin connector. If battery voltage is not present, repair Blue wire between DOOR LOCK fuse and control switch. If battery voltage is present, disconnect control switch connector. Check continuity between ground and Black wire terminal of control switch connector.
- If continuity does not exist, repair Black wire between ground and control switch. If continuity exists, reconnect control switch connector. Measure voltage at wire terminals of control switch connector with control switch in specified position. See VOLTAGE TEST .
- If battery voltage is present at all wire terminals of control switch connector, go to next step. If battery voltage is not present at any wire terminal of control switch connector, check control switch. See CONTROL SWITCH TEST under COMPONENT TESTING.
- Measure voltage at wire terminals of specified motor connector with control switch in specified position. See VOLTAGE TEST . If battery voltage is present at all wire terminals of all motor connectors, check motors. See MOTOR TEST under COMPONENT TESTING.
- If battery voltage is not present at any wire terminal of slide, front lift and rear lift motor connectors, repair wiring between specific motor and control switch. If battery voltage is not present at any wire terminal of recline motor connector, replace recline motor.