LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mazda >> 1994 >> 626 DX, Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - System/Component Tests >> Engine Sensors & Switches >> Oxygen (O2S) Sensor
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

Oxygen (O2S) Sensor

  1. Warm engine to operating temperature. Operate engine at idle. Disconnect O2S sensor electrical connector. Connect voltmeter between O2S sensor connector terminals "C" and "D" on 2.5L, or terminals "A" and "B" on 2.0L. See Fig 1 .
  2. Observe voltmeter while rapidly accelerating and decelerating engine speed. Voltage should be 0.5-1.0 volt during acceleration and 0.0-0.4 volt during deceleration. Replace O2S sensor as necessary.
Fig 1: Testing Oxygen Sensor (MX-6 & 626)
G93D80484Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals