Engine Controls - Basic Testing
- Introduction
- Preliminary Inspection & Adjustments
- Fuel System
- Ignition Checks (Except NAVAJO)
- Spark
- Ignition Coil Power Source
- Ignition Coil Resistance (Except MX-3 1.8L, MX-6 & 626)
- Ignition Coil Resistance (MX-3 1.8L, MX-6 & 626)
- Optical Distributor Voltage (B2200 PFI, B2600 & MPV 2.6L)
- Distributor Pick-Up Coil Resistance (B2200 CARBURETED)
- Distributor Pick-Up Coil Resistance (MPV 3.0L)
- Crank Angle Sensor Resistance (MX-3 1.8L, MX-6 & 626 2.5L, RX7 & 929)
- Hall-Effect Sensors (MIATA, MX-3, MX-6, Protege, 323, 626 & 929)
- IGNITOR (B2200 W/Carburetor, MX-3 1.8L, MX-6 & 626)
- IGNITOR (B2200 W/PFI, B2600I, MIATA, MX-3 1.6L, Protege, 323 & 929)
- IGNITOR (MPV & 929)
- IGNITOR (RX7)
- Ignition Checks (NAVAJO)
- Notes
- Initial Test
- Check Profile Ignition Pickup (Pip) At ICM
- Isolate ICM/Pip Fault
- Checking Plugs & Wires
- Check For VBAT To ICM
- Check For Ground Open To ICM
- Check VRS Resistance
- VRS Sensor
- Check VBAT For Open To Coil
- Verify Coil Operation
- Check C1, C2 & C3 At Coil Pack (Cranking)
- Check C1, C2 & C3 At Coil Pack (Running)
- Checking Coil Pack
- Checking ICM Control
- Idle Speed & Ignition Timing
- Summary