October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.
Except Navajo
- On B2200 PFI, B2600i, MPV, MX-6, RX7, 626 and 929, connect jumper wire between terminals of Yellow 2-pin connector. See FUEL PUMP TEST CONNECTOR LOCATION
table.
- On Miata, Protege and 323, connect jumper wire between GRN and F/P terminals of diagnostic connector. See Fig 1
. On all models, turn ignition on for about 10 seconds, then turn ignition off. Disconnect jumper wire.
Courtesy of MAZDA MOTORS CORP. FUEL PUMP TEST CONNECTOR LOCATION
| Application |
Location |
| B2200 PFI & B2600i |
In Right Rear Corner Of Engine Compartment |
| MPV & 929 |
In Left Front Corner Of Engine Compartment |
| MX-6 & 626 |
Near Left Strut Tower |
| RX7 |
In Right Front Corner Of Engine Compartment |