LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lincoln >> 2018 >> Navigator Black Label >> Repair and Diagnosis >> Brakes >> Brakes Control Systems >> Abs Guided Routine Testing >> Pinpoint Tests >> Pinpoint Test Z: ABS Module Configuration Concern >> Normal Operation and Fault Conditions
October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.

Normal Operation and Fault Conditions

During new module installation, configuration files are loaded into the new module being replaced. If a discrepancy is detected between the modules or an incomplete programming procedure is carried out, a DTC sets. 

PPT Z ABS MODULE DTC FAULT TRIGGER CONDITIONS

DTC Description Fault Trigger Conditions
P05D3:57 Driver Mode Select Switch "A" Range/Performance: Invalid/Incompatible Software Component This DTC sets due to incomplete or improper module programming procedures. The module must be reconfigured using as-built data.
U0300:51 Internal Control Module Software Incompatibility: Not Programmed This DTC sets when the software release level has not been programmed into the module. This is most likely due to incomplete or improper module programming procedures.
U2100:46 Initial Configuration Not Complete: Calibration/Parameter Memory Failure This DTC is preset in a new ABS module and clears automatically when the ABS module is configured correctly. This DTC also sets due to incomplete or improper module programming procedures.
U2100:51 Initial Configuration Not Complete: Not Programmed This DTC is preset in a new ABS module and clears automatically when the ABS module is configured correctly. This DTC also sets due to incomplete or improper module programming procedures.
U2100:56 Initial Configuration Not Complete: Invalid/Incompatible Configuration This DTC sets due to incomplete or improper module programming procedures.
U2100:57 Initial Configuration Not Complete: Invalid/Incompatible Software Component This DTC is preset in a new ABS module and clears automatically when the ABS module is configured correctly. This DTC also sets due to incomplete or improper module programming procedures.
U2101:55 Control Module Configuration Incompatible: Not Configured This DTC sets due to incomplete or improper module programming procedures.
U2101:56 Control Module Configuration Incompatible: Invalid/Incompatible Configuration This DTC sets due to incomplete or improper module programming procedures.
U2101:57 Control Module Configuration Incompatible: Invalid/Incompatible Software Component This DTC sets due to incomplete or improper module programming procedures.
U2200:00 Control Module Configuration Memory Corrupt: No Sub Type Information This DTC sets due to incomplete or improper module programming procedures.
U2200:83 Control Module Configuration Memory Corrupt: Value of Signal Protection Calculation Incorrect This DTC sets due to incomplete or improper module programming procedures.
scientia non olet · About LEMON Manuals