Compressor to Condenser Discharge Line: Removal
NOTE:
Removal steps in this procedure may contain installation details.
- 1.
Recover the refrigerant. Refer to Climate Control System - General Information and Diagnostics .
- 2.
Remove the Right Hand(RH) headlamp assembly. Refer to Exterior Lighting .
- 3.
Loosen the Air Cleaner(ACL) outlet pipe clamp and disconnect the ACL outlet pipe.- Tighten to 5 Nm (44 lb-in).
- 4.
Loosen the ACL outlet pipe clamp and remove the Air Cleaner(ACL) outlet pipe.- Tighten to 5 Nm (44 lb-in).
- 5.
Remove the compressor discharge fitting nut and disconnect the fitting.- Discard the O-ring seal and gasket seal.
- To install, tighten to 15 Nm (133 lb-in).
NOTE:
Make sure that all openings are sealed.
- 7.
Remove the condenser inlet fitting nut and remove the compressor-to-condenser discharge line.- Discard the O-ring and gasket seals.
- To install, tighten to 15 Nm (133 lb-in).
NOTE:
Make sure that all openings are sealed.