Remote Function Actuator (RFA) Module
DTC INDEX
| DTC | Description | Action |
|---|---|---|
| B10AB:06 | Remote Keyless Entry Synchronization: Algorithm Based Failures | GO to Pinpoint Test AF . |
| B10C6:01 | Exterior Trunk Antenna: General Electrical Failure | GO to Pinpoint Test AE . |
| B10D7:31 | PATS Key: No Signal | May indicate 2 Intelligent Access (IA) keys were not inside the vehicle during the Remote Function Actuator (RFA) module self-test. Make sure 2 IA keys are inside the vehicle. CLEAR the DTCs. REPEAT the self-test. |
| B113E:11 | External Boot/Trunk Release Switch: Circuit Short To Ground | GO to Pinpoint Test AE . |
| B11C6:01 | Passenger Door External Antenna: General Electrical Failure | GO to Pinpoint Test AD . |
| B11CA:01 | Driver Door External Antenna: General Electrical Failure | GO to Pinpoint Test AD . |
| B121A:11 | Keypad Illumination Output: Circuit Short To Ground | GO to Pinpoint Test AC . |
| B121A:15 | Keypad Illumination Output: Circuit Short To Battery Or Open | GO to Pinpoint Test AC . |
| B121B:11 | Keypad Input Switch: Circuit Short To Ground | GO to Pinpoint Test AB . |
| B1381:11 | Left Front Door Handle Proximity Sensor: Circuit Short To Ground | GO to Pinpoint Test AD . |
| B1381:15 | Left Front Door Handle Proximity Sensor: Circuit Short To Battery or Open | GO to Pinpoint Test AD . |
| B1381:29 | Left Front Door Handle Proximity Sensor: Signal Invalid | CLEAR the DTCs. REPEAT the self-test. If DTC B1381:29 returns, INSTALL a new LF exterior door handle. REFER to Exterior Door Handle . TEST the system for normal operation. |
| B1382:11 | Right Front Door Handle Proximity Sensor: Circuit Short To Ground | GO to Pinpoint Test AD . |
| B1382:15 | Right Front Door Handle Proximity Sensor: Circuit Short To Battery or Open | GO to Pinpoint Test AD . |
| B1382:29 | Right Front Door Handle Proximity Sensor: Signal Invalid | CLEAR the DTCs. REPEAT the self-test. If DTC B1382:29 returns, INSTALL a new RF exterior door handle. REFER to Exterior Door Handle . TEST the system for normal operation. |
| U201F:31 | External Receiver: No Signal | GO to Pinpoint Test AF . |
| All other DTCs | - | REFER to the Diagnostic Trouble Code (DTC) Chart in Multifunction Electronic Modules . |