Removal And Installation
- Verify the current APIM software and hardware level. For additional information, refer to Accessory Protocol Interface Module (APIM) Reprogramming MODULE CONFIGURATION article.
- Remove the floor console. For additional information, refer to INSTRUMENT PANEL AND CONSOLE article.
- Remove the floor console rear trim panel by pulling straight back to disengage the clips.
- Remove the 2 screws (Fusion, Milan) or 4 screws (MKZ) and the APIM.
- Disconnect the APIM electrical connector.
- Disconnect the Universal Serial Bus (USB) cable.
- To install, reverse the removal procedure.
- Reprogram the APIM. For additional information, refer to MODULE CONFIGURATION article.
NOTE:
Accessory Protocol Interface Module (APIM) reprogramming is only necessary if a new module is being installed.
NOTE:
For Fusion, Milan, the APIM is removed as an assembly with the bracket.