Removal And Installation

Remove the air cleaner assembly. For additional information, refer to INTAKE AIR DISTRIBUTION AND FILTERING article.
Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES article.
Disconnect the anti-lock brake system (ABS) module electrical connector.
Disconnect the hydraulic control unit (HCU) pump motor electrical connector.

NOTE: Care must be taken when removing the module from the hydraulic control unit (HCU).

Remove the ABS module.
- Remove the screws in the sequence shown.
- To install, tighten to 3 Nm (27 lb-in).

Fig 1: ABS Module Screws Removal Sequence

Courtesy of FORD MOTOR CO.

NOTE: Make sure that the ABS module-to-HCU gasket surfaces are clean and that the gasket is correctly installed.