Floor Jack
- The front of the vehicle may be lifted by positioning a jack under the center of front crossmember, lower control arm-to-spindle connection or side rail where stabilizer is connected. The rear end may be lifted by positioning floor jack under the rocker flange at contact points used for vehicle jack or under differential housing.
- Make sure that jack does not make contact with differential housing cover. Position jack stands under front lower control arms or rear axle housing between suspension arm brackets and differential housing. DO NOT place jack stands under suspension arm brackets. See Fig 1 .
NOTE:
On vehicles with air suspension, disconnect electrical power by removing negative battery cable or shutting off air suspension switch located in trunk. Switch is located in trunk on left front side of inner panel.