LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lincoln >> 1985 >> Mark VII Base, 5.0 F >> Repair and Diagnosis >> Engine Performance >> System >> Fuel Injection System - 6-CYL Diesel >> Testing >> Glow Plugs >> Resistance Test
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Resistance Test

  1. Remove glow plug control module cover. Remove large connector from module. Connect one lead of ohmmeter to ground and other lead into each terminal of large connector. See Fig 1 .
    Fig 1: Module Test Points Test points are shown with cover removed.
    G3313
  2. Resistance of each glow plug should be .3-.6 ohms. If resistance is correct, go to GLOW PLUG MODULE  .
  3. If an open circuit condition exists, replace glow plug. If resistance is not within specifications (after replacing a bad plug), wiring between module and glow plug must be replaced.
NOTE: Prior to glow plug installation, coat glow plug threads with anti-seize compound.
scientia non olet · About LEMON Manuals