LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lincoln >> 1984 >> Mark VII LSC, 5.0 F >> Repair and Diagnosis >> Engine Performance >> Ignition System >> Ignition System - TFI-IV >> Removal & Installation >> TFI Ignition Module >> Removal & Installation (Except 3.8L)
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal & Installation (Except 3.8L)

  1. Remove distributor from engine. With distributor on workbench, remove 2 module mounting screws. Slide right side of module down toward distributor mounting flange, and then back up. Move left side of module down toward distributor mounting flange and then back up.
  2. Alternate sliding right and left sides of module until module terminals are disengaged from connector in distributor. Any attempt to pull module from mounting surface prior to moving it toward distributor flange WILL BREAK module electrical connector pins.
  3. To install, reverse removal procedure. Apply a 1/32" thick ribbon of Silicone Dielectric Compound (D7AZ-19A331-A) to TFI ignition module base plate. Adjust base ignition timing.
scientia non olet · About LEMON Manuals