LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2021 >> RC F Fuji Speedway Edition >> Repair and Diagnosis >> Maintenance >> Procedures >> Maintenance Reminder Light (Reset Procedures) >> Tire Pressure Monitor System Reminder >> TPMS Reminder Reset - Procedure 01 >> Confirmation Of Transmitter ID Registration
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Confirmation Of Transmitter ID Registration

  1. Set the tire pressure of all wheels to the specified value.
  2. Connect the intelligent tester to DLC3.
  3. Turn the ignition switch to the ON position.
  4. Select the "SIGNAL CHECK" mode on the intelligent tester.
  5. Forcibly transmit the transmitter IDs for all wheels.
    6. NOTE:
    • The transmitter ID can be transmitted by rapidly reducing the tire air pressure.
    • When rapidly reducing the pressure, loosen the valve core.
    • Increase or decrease the tire inflation pressure by 40 kPa (0.4 kgf/cm2, 5.8 psi) or more within 30 seconds for each tire.
  6. Check that test mode DTCs C2191/81, C2192/82, C2193/83, C2194/84 and C2195/85 are all erased.
    7. NOTE: If they haven't been erased, reset the tire pressure to the specified value and rotate the tire 90 to 270 degrees. Then forcibly transmit the transmitter IDs of all wheels. If they are still output, register the transmitter IDs.
  7. Set the tire pressure of all wheels to the specified value.
scientia non olet · About LEMON Manuals