LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2017 >> ES 350 >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Engine Control System (Service Information) >> Heated Oxygen Sensor >> Inspection [07/2015 - ] >> Procedure
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Inspection [07/2015 - ]: Procedure

  1. INSPECT HEATED OXYGEN SENSOR (for Bank 1 Sensor 2) 
    1. Measure the resistance according to the value(s) in the table below.
      GTY316497Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Standard Resistance

      Tester Connection Condition Specified Condition
      1 (HT1B) - 2 (+B) 20°C (68°F) 11 to 16 Ω
      1 (HT1B) - 4 (E2) - 10 kΩ or higher
      TEXT IN ILLUSTRATION

      *a Component without harness connected
      (Heated Oxygen Sensor)

      If the resistance is not as specified, replace the heated oxygen sensor.

  2. INSPECT HEATED OXYGEN SENSOR (for Bank 2 Sensor 2) 
    1. Measure the resistance according to the value(s) in the table below.
      GTY290280Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Standard Resistance

      Tester Connection Condition Specified Condition
      1 (HT2B) - 2 (+B) 20°C (68°F) 11 to 16 Ω
      1 (HT2B) - 4 (E2) - 10 kΩ or higher
      TEXT IN ILLUSTRATION

      *a Component without harness connected
      (Heated Oxygen Sensor)

      If the resistance is not as specified, replace the heated oxygen sensor.

scientia non olet · About LEMON Manuals