Removal (08/2011 - ): Removal

REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH . Refer to REMOVAL - Step 1
REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH . Refer to REMOVAL - Step 2
REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY . Refer to REMOVAL - Step 6
REMOVE ENGINE ROOM SIDE COVER LH . Refer to REMOVAL - Step 1
REMOVE ENGINE ROOM SIDE COVER RH . Refer to REMOVAL - Step 2
REMOVE UPPER RADIATOR SUPPORT SEAL . Refer to REMOVAL - Step 3
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTE:
- After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Refer to INITIALIZATION .
REMOVE V-BANK COVER SUB-ASSEMBLY . Refer to REMOVAL - Step 4
REMOVE AIR CLEANER HOSE ASSEMBLY . Refer to REMOVAL - Step 11
REMOVE AIR CLEANER ASSEMBLY . Refer to REMOVAL - Step 29
REMOVE FAN & GENERATOR V BELT . Refer to REMOVAL - Step 8
DRAIN POWER STEERING FLUID
REMOVE FRONT WHEEL
REMOVE FRONT FENDER APRON SEAL FRONT RH . Refer to REMOVAL - Step 8
REMOVE FRONT HEIGHT CONTROL SENSOR SUB-ASSEMBLY RH
1. Disconnect the connector.
  
  Fig 1: Locating Front Height Control Sensor Connector And Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Remove the nut, bolt and sensor.
REMOVE POWER STEERING OIL PRESSURE SWITCH
1. Disconnect the switch connector.
  
  Fig 2: Locating Power Steering Oil Pressure Switch Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Using a 24 mm deep socket wrench, remove the oil pressure switch.
3. Remove the O-ring.