Installation

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: SKID CONTROL ECU: INSTALLATION

INSTALLATION

1. INSTALL SKID CONTROL ECU





(a) Install the skid control ECU with the 3 screws.
Torque: 5.5 Nm (56 kgf-cm, 49 in-lbf)
- Align positioning boss (A) of the blower assembly with the hole of the skid control ECU.
- Securely engage hook (B) of the skid control ECU with the blower assembly.





(b) Connect the 3 connectors to the skid control ECU.
2. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Installation
3. INSTALL SIDE INSTRUMENT PANEL RH Installation
4. INSTALL FRONT DOOR OPENING TRIM COVER RH Installation
5. INSTALL FRONT DOOR SCUFF PLATE RH Installation
6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
7. PERFORM YAW RATE AND ACCELERATION SENSOR ZERO POINT CALIBRATION
Testing and Inspection
8. CHECK FOR SENSOR SIGNAL
Test Mode Procedure
9. CHECK AND CLEAR DTC
HINT: Reading and Clearing Diagnostic Trouble Codes