Removal

2GR-FSE ENGINE CONTROL SYSTEM: CRANKSHAFT POSITION SENSOR: REMOVAL

REMOVAL

1. REMOVE COOL AIR INTAKE DUCT SEAL Removal
2. REMOVE V-BANK COVER SUB-ASSEMBLY Removal
3. REMOVE NO. 1 INLET AIR CLEANER Removal
4. DISCHARGE REFRIGERANT FROM REFRIGERATION SYSTEM Removal
5. REMOVE V-RIBBED BELT Removal
6. REMOVE ENGINE UNDER COVER
7. REMOVE REAR ENGINE UNDER COVER LH
8. DISCONNECT NO. 1 COOLER REFRIGERANT SUCTION HOSE Removal
9. DISCONNECT DISCHARGE HOSE SUB-ASSEMBLY Removal
10. REMOVE COMPRESSOR WITH PULLEY ASSEMBLY Removal
11. REMOVE CRANKSHAFT POSITION SENSOR





(a) Disconnect the crankshaft position sensor connector.
(b) Remove the bolt and crankshaft position sensor.