LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2009 >> IS 250 AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 58 (Can Communication System (Diagnostics)) >> Can Communication System >> Center Airbag Sensor Communication Stop Mode >> Procedure
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Center Airbag Sensor Communication Stop Mode: Procedure

WARNING: This page is about a different car, the 2009 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK OPEN IN CAN BUS WIRE (CENTER AIRBAG SENSOR BRANCH LINE) 
    1. Turn the engine switch off.
    2. Disconnect the center airbag sensor connector (J47).
    3. Measure the resistance according to the value(s) in the table below.
      Fig 1: Identifying Center Airbag Sensor Connector J47
      GTY114196Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Standard Resistance

      Tester Connection Condition Specified Value
      J47-13 (CANH) - J47-22 (CANL) Engine switch off 54 to 69 Ω

    NG → REPAIR OR REPLACE CENTER AIRBAG SENSOR BRANCH WIRE OR CONNECTOR (CANH, CANL) 

    OK: Go to next step 

  2. CHECK WIRE HARNESS (IG2, E1, E2) 
    1. Measure the resistance according to the value(s) in the table below.
      Fig 2: Identifying Center Airbag Sensor Connector J47
      GTY141194Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Standard Resistance

      Tester Connection Condition Specified Value
      J47-25 (E1) - Body ground Always Below 1 Ω
      J47-26 (E2) - Body ground Always Below 1 Ω
    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage

      Tester Connection Condition Specified Value
      J47-21 (IG2) - Body ground Engine switch on (IG) 10 to 14 V

    NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

    OK → See step   3 

  3. REPLACE CENTER AIRBAG SENSOR ASSEMBLY. Refer to  REMOVAL 
scientia non olet · About LEMON Manuals