Removal

AUDIO / VISUAL: NETWORK GATEWAY ECU:

REMOVAL

1. TABLE OF BOLT, SCREW AND NUT Removal

2. SET RADIO RECEIVER ASSEMBLY TO SHIPMENT MODE Removal

3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

4. INSPECT CENTER FRONT WHEEL
5. REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY
(a) Remove the instrument panel safety pad Removal.
6. REMOVE STEERING COLUMN ASSEMBLY Disassembly

7. REMOVE NO. 1 INSTRUMENT PANEL PIN Disassembly

8. REMOVE NO. 1 SIDE DEFROSTER NOZZLE DUCT Disassembly

9. REMOVE NO. 2 SIDE DEFROSTER NOZZLE DUCT Disassembly

10. REMOVE FRONT DEFROSTER NOZZLE Disassembly

11. REMOVE NO. 1 HEATER TO REGISTER DUCT Disassembly

12. REMOVE NO. 3 HEATER TO REGISTER DUCT Disassembly

13. REMOVE NO. 2 HEATER TO REGISTER DUCT Disassembly

14. REMOVE INSTRUMENT PANEL REINFORCEMENT Disassembly

15. REMOVE NETWORK GATEWAY ECU






(a) Remove the 2 screws and ECU.