LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2008 >> LX 570 >> Repair and Diagnosis >> Accessories & Equipment >> Communication Devices >> Networking >> Network Gateway Ecu >> Installation
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Network Gateway Ecu: Installation

  1. INSTALL NETWORK GATEWAY ECU 
    1. Install the ECU with the nut.
    2. Connect the connector.
      3. Fig 1: Locating Nut And ECU
      G05639637Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL  (See INSTALLATION )
  3. INSTALL INSTRUMENT PANEL BOX DOOR KNOB  (See INSTALLATION )
  4. INSTALL FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY  (See INSTALLATION )
  5. INSTALL COWL SIDE TRIM BOARD RH  (See INSTALLATION )
  6. INSTALL FRONT DOOR SCUFF PLATE RH  (See INSTALLATION )
  7. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY  (See INSTALLATION )
  8. INSTALL INNER NO. 1 INSTRUMENT PANEL BRACKET COVER RH  (See INSTALLATION )
  9. INSTALL LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY RH  (See INSTALLATION )
  10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
    NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).
  11. INSTALL ENGINE ROOM SIDE COVER LH  (See INSTALLATION )
  12. CHECK SRS WARNING LIGHT 
    1. Check the SRS warning light (See CHECK MODE PROCEDURE ).
scientia non olet · About LEMON Manuals