How To Proceed With Troubleshooting

HINT

• Use the following procedure to troubleshoot the lighting system
• * Use the Techstream

1. VEHICLE BROUGHT TO WORKSHOP 
2. CUSTOMER PROBLEM ANALYSIS AND SYMPTOM CHECK 
3. INSPECT BATTERY VOLTAGE 

   Standard Voltage: 

   11 to 14 V 

   If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step

4. INSPECT MULTIPLEX COMMUNICATION SYSTEM (BEAN)* 
   1. Use the Techstream to check if the Multiplex Communication System (MPX) is functioning normally

      Result 

      RESULT CHART
      
      

      Result	Proceed to
      MPX DTC is not output	A
      MPX DTC is output	B

   B: Go to step  7

   A: Go to next step 

5. PROBLEM SYMPTOMS TABLE 

   Result 

   RESULT CHART
   
   

   Result	Proceed to
   If fault is not listed in problem symptoms table	A
   If fault is listed in problem symptoms table	B

   B: Go to step  7

   A: Go to next step 

6. OVERALL ANALYSIS AND TROUBLESHOOTING* 
   1. Data List / Active Test (See DATA LIST / ACTIVE TEST  )
   2. Terminals of ECU (See TERMINALS OF ECU  )
   3. Inspection
7. ADJUST, REPAIR OR REPLACE 
8. CONFIRMATION TEST 

   NEXT: END