DTC Check/Clear

1. Check for DTCs
   1. Using SST, connect terminals TC and CG of the DLC3

      SST 09843-18040 

   2. Turn the engine switch on (IG).
      Fig 1: Identifying DLC3 Connector Terminals

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   3. Read and record any DTCs indicated by the multi-information display on the combination meter.

      HINT.

      • If the multi-information display does not indicate any DTCs or the normal system code, inspect the TC and CG terminal circuit.
        TROUBLE AREA REFERENCE CHART
        
        

        Trouble Area	See Procedure
        TC and CG terminal circuit	TC AND CG TERMINAL CIRCUIT

      • If 2 or more malfunctions are indicated at the same time, the lowest numbered DTC is displayed first.
        Fig 2: Identifying Multi-Information Display

        Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   4. Refer to the DIAGNOSTIC TROUBLE CODE CHART  for DTC information.
   5. After completing the check, turn the engine switch off and remove SST from the DLC3.

      SST 09843-18040 

1. Turn the engine switch off.
2. Connect the Techstream to the DLC3.
3. Turn the engine switch on (IG).
4. Turn the Techstream on.
5. Read the DTCs following the prompts on the Techstream Enter the following menus: Chassis / Tire Pressure Monitor/ Trouble Codes.
6. Refer to the DIAGNOSTIC TROUBLE CODE CHART  for DTC information .

HINT:

After repairing the malfunctions, clear the DTCs

1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Turn the Techstream on
4. Clear the DTCs following the prompts on the Techstream Enter the following menus: Chassis / Tire Pressure Monitor/ Trouble Codes.
5. According to the display on the Techstream, select the trouble code data display with the clear button.