LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2008 >> IS 250 AWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System (4GR-FSE) - System And Component Testing, On-Vehicle Inspection, Removal, Inspection & Installation >> Engine Coolant Temperature Sensor >> Removal
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Engine Coolant Temperature Sensor: Removal

  1. REMOVE COOL AIR INTAKE DUCT SEAL  (See REMOVAL )
  2. REMOVE ENGINE ROOM SIDE COVER LH  (See REMOVAL )
  3. REMOVE ENGINE ROOM SIDE COVER RH  (See REMOVAL )
  4. REMOVE V-BANK COVER SUB-ASSEMBLY  (See REMOVAL )
  5. REMOVE FRONT FENDER PROTECTOR UPPER LH  (See REMOVAL )
  6. REMOVE FRONT FENDER PROTECTOR UPPER RH  (See REMOVAL )
  7. REMOVE ROOF DRIP SIDE FINISH MOLDING LH  (See REMOVAL )
  8. REMOVE ROOF DRIP SIDE FINISH MOLDING RH  (See REMOVAL )
  9. REMOVE FRONT WIPER ARM HEAD CAP  (See REMOVAL )
  10. REMOVE WINDSHIELD WIPER ARM AND BLADE ASSEMBLY LH  (See REMOVAL )
  11. REMOVE WINDSHIELD WIPER ARM AND BLADE ASSEMBLY RH  (See REMOVAL )
  12. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY  (See REMOVAL )
  13. DRAIN ENGINE COOLANT  (See ON-VEHICLE INSPECTION )
  14. DISCONNECT NO. 2 VENTILATION HOSE  (See ON-VEHICLE INSPECTION )
  15. REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE  (See REMOVAL )
  16. REMOVE THROTTLE BODY  (See REMOVAL )
  17. REMOVE COLD START INJECTOR  (See REMOVAL )
  18. REMOVE INTAKE AIR SURGE TANK ASSEMBLY  (See REMOVAL )
  19. REMOVE INTAKE MANIFOLD  (See REMOVAL )
  20. REMOVE ENGINE COOLANT TEMPERATURE SENSOR 
    1. Disconnect the engine coolant temperature sensor connector.
    2. Remove the engine coolant temperature sensor.
    3. Remove the gasket from the engine coolant temperature sensor.
    Fig 1: Locating Engine Coolant Temperature Sensor Connector
    G05285367Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals