Inspection Procedure

1. Select the ACTIVE TEST, use the Techstream (with CAN VIM) to generate a control command, and then check that the CRUISE main indicator light illuminates.

   Combination meter 

   DTC DETECTION CONDITION CHART
   
   

   Tester Display	Test Part	Control Range	Diagnostic Note
   Indicat. Lamp Cruise	CRUISE main Indicator light	ON / OFF	-

   OK: 

   Indicator light turns on / turns off. 

NG: GO TO METER / GAUGE SYSTEM  (See HOW TO PROCEED WITH TROUBLESHOOTING )

OK: Go to Next Step 

1. Check the DATA LIST for proper functioning of the CRUISE main indicator light.

   Hybrid vehicle control ECU 

   NORMAL CONDITION CHART
   
   

   Tester Display	Measurement Item / Range	Normal Condition	Diagnostic Note
   CCS Indicator M-CPU	Cruise indicator signal (Main CPU) / ON or OFF	ON: "CCS READY" ON OFF: "CCS READY" OFF	-

   OK: 

   When cruise control main switch operation is performed, the result will be same as above. 

NG: REPLACE CRUISE CONTROL MAIN SWITCH 

OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE  (See PROBLEM SYMPTOMS TABLE  )