October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.
Crankshaft Position Sensor: Removal
- DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
- REMOVE COOL AIR INTAKE DUCT SEAL
(See REMOVAL
)
- REMOVE V-BANK COVER
(See REMOVAL
)
- REMOVE NO. 1 AIR CLEANER INLET
(See REMOVAL
)
- DISCHARGE REFRIGERANT FROM REFRIGERATION SYSTEM
(See REPLACEMENT
)
- REMOVE ENGINE UNDER COVER (for 2WD)
- REMOVE ENGINE UNDER COVER (for 4WD)
- REMOVE REAR ENGINE UNDER COVER LH (for 2WD)
- REMOVE V-RIBBED BELT
(See REMOVAL
)
- REMOVE OIL FILTER BRACKET (for 4WD)
(See REMOVAL
)
- REMOVE OIL FILTER BRACKET SUB-ASSEMBLY (for 4WD)
(See REMOVAL
)
- DISCONNECT NO. 1 COOLER REFRIGERANT SUCTION HOSE
(See REMOVAL
)
- DISCONNECT DISCHARGE HOSE SUB-ASSEMBLY
(See REMOVAL
)
- REMOVE COOLER COMPRESSOR ASSEMBLY (for 2WD)
(See REMOVAL
)
- REMOVE COOLER COMPRESSOR ASSEMBLY (for 4WD)
(See REMOVAL
)
- REMOVE CRANKSHAFT POSITION SENSOR
- Disconnect the sensor connector.
- Remove the bolt and sensor.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002