Inspection Procedure
WARNING: This page is about a different car, the 2008 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
When replacing the ABS and TRACTION actuator, perform the zero point calibration (see CALIBRATION
).
- CHECK CAN COMMUNICATION SYSTEM
- Check if the CAN communication system DTC is output (see DIAGNOSIS SYSTEM
).
Result
DTC RESULT DESCRIPTIONResult Proceed to DTC is not output A DTC is output B
B: REPAIR CAN COMMUNICATION SYSTEM
A: Go to next step.
- Check if the CAN communication system DTC is output (see DIAGNOSIS SYSTEM
).
- CHECK SKID CONTROL ECU CONNECTOR
- Check if the skid control ECU connector is securely connected.
OK: The connector is securely connected.
NG: CONNECT CONNECTOR CORRECTLY
OK: Go to next step.
- Check if the skid control ECU connector is securely connected.
- CHECK COMBINATION METER
- Check the combination meter (see HOW TO PROCEED WITH TROUBLESHOOTING ).
NG: REPLACE COMBINATION METER
OK: REPLACE ABS AND TRACTION ACTUATOR ASSEMBLY