LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2007 >> RX 400h AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 249 (Parking Brake) >> Parking Brake Switch >> Installation
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

Parking Brake Switch: Installation

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL PARKING BRAKE SWITCH 
    1. Install the parking brake switch with the screw.

      Torque: 0.9 N*m (9 kgf*cm, 8 in.*lbf) 

    2. Connect the parking brake switch connector.
  2. INSTALL REAR CONSOLE BOX ASSEMBLY (See  INSTALLATION   ) 
  3. INSTALL CONSOLE BOX CARPET (See  INSTALLATION   ) 
  4. INSTALL REAR CONSOLE BOX COVER (for Hatchback) (See  INSTALLATION   ) 
    Fig 1: Locating Parking Brake Switch Screws
    G04832413Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  5. INSTALL REAR UPPER CONSOLE PANEL SUB-ASSEMBLY (for Sedan) (See  INSTALLATION   ) 
  6. INSTALL SHIFTING HOLE COVER SUB-ASSEMBLY (for Hatchback Manual Transaxle) (See  INSTALLATION   ) 
  7. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY (for Sedan) (See  INSTALLATION   ) 
  8. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transaxle) 
  9. INSTALL CENTER LOWER INSTRUMENT PANEL FINISH PANEL (for Sedan) (See  INSTALLATION   ) 
  10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 

    Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf) 

scientia non olet · About LEMON Manuals