LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2007 >> RX 350 FWD >> Repair and Diagnosis >> Engine Performance >> Fuel Delivery >> Fuel >> Fuel Pressure Pulsation Damper >> Removal
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

Fuel Pressure Pulsation Damper: Removal

  1. DISCHARGE FUEL SYSTEM PRESSURE 

    HINT:

    See PRECAUTION  .

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
  3. DRAIN ENGINE COOLANT  (See ON-VEHICLE INSPECTION )
  4. REMOVE ENGINE ROOM COVER SIDE  (See REMOVAL )
  5. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH  (See REMOVAL )
  6. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH  (See REMOVAL )
  7. REMOVE FRONT FENDER TO COWL SIDE SEAL LH 
  8. REMOVE FRONT FENDER TO COWL SIDE SEAL RH 
  9. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY  (See REMOVAL )
  10. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY  (See REMOVAL )
  11. REMOVE COWL TOP PANEL OUTER SUB-ASSEMBLY  (See REMOVAL )
  12. REMOVE V-BANK COVER SUB-ASSEMBLY  (See REMOVAL )
  13. REMOVE AIR CLEANER CAP SUB-ASSEMBLY  (See REMOVAL )
  14. REMOVE INTAKE AIR SURGE TANK ASSEMBLY  (See REMOVAL )
  15. REMOVE FUEL PRESSURE PULSATION DAMPER ASSEMBLY 
    1. Remove the clip.
    2. Pull out the fuel pressure pulsation clamper from the fuel delivery pipe.
      3. Fig 1: Identifying Fuel Pressure Pulsation Damper
      G04975030Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Remove the O-ring from the fuel pressure pulsation damper.
scientia non olet · About LEMON Manuals