Inspection Procedure
HINT:
Using the intelligent tester's DATA LIST allows switch, sensor, actuator and other item values to be read without removing any parts. Reading the DATA LIST early in troubleshooting is one way to save time.
NOTE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
- Warm up the engine.
- Turn the ignition switch OFF.
- Connect the intelligent tester to the CAN VIM. Then connect the CAN VIM to the DLC3.
- Turn the ignition switch ON.
- Turn the intelligent tester ON.
- Enter the following menus: DIAGNOSIS / OBD/MOBD / ECT / DATA LIST.
- Follow the instructions on the tester and read the DATA LIST.NORMAL CONDUCTION REFERENCE VALUE
Tester Display Measurement Item/Range Normal Condition Diagnostic Note A/T OIL TEMPI ATF temperature sensor No. 1 value/ Min.: -40°C (-40°F)
Max.: 215°C (419°F)- After stall test: Approximately 80°C (176°F)
- Equal to ambient temperature while engine is cold
If value is -40°C (-40°F) or 215°C (419°F), ATF temperature sensor No. 1 circuit is opened or short circuited
HINT:
- When DTC P0712 is output and the intelligent tester output is 150°C (302°F) or more, there is a short circuit.
- When DTC P0713 is output and the intelligent tester output is -40°C (-40°F), there is an open circuit. Measure the resistance between terminal THO1 (OT) and the body ground.
TEMPERATURE REFERENCE
| Temperature Displayed | Malfunction |
|---|---|
| -40°C (-40°F) | Open circuit |
| 150°C (302°F)or more | Short circuit |
HINT:
If a circuit related to the ATF temperature sensor becomes open, P0713 is set in approximately 0.5 seconds. It is not necessary to inspect the circuit when P0711 is set.
- CHECK OTHER DTCS OUTPUT (IN ADDITION TO DTC P0711)
- Connect the intelligent tester to the CAN VIM. Then connect the CAN VIM to the DLC3.
- Turn the ignition switch ON and push the intelligent tester main switch ON.
- Enter the following menus: DIAGNOSIS / ENHANCED OBD II / DTC INFO / CURRENT CODES.
- Read the DTCs using the intelligent tester.
Result
DTC RESULT REFERENCEDisplay (DTC output) Proceed to Only P0711 is output A P0711 and other DTCs B HINT:
If any other codes besides P0711 are output, perform troubleshooting for those DTCs first.
B: GO TO DTC CHART
A: Go to Next Step
- CHECK TRANSMISSION FLUID LEVEL
OK: Automatic transmission fluid level is correct.
NG: ADD FLUID
OK: REPLACE TRANSMISSION WIRE