October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.
Wake-up operation
WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
- BCM changes from the low power consumption mode to the CAN communication sleep mode when the any of the BCM wake-up conditions is fulfilled. Only the control with BCM is activated.
- BCM transmits the sleep wake up signal (wake up) to each unit when any of the CAN wake-up conditions is fulfilled. It changes from the low power consumption mode or the CAN communication sleep mode to the normal mode.
- Each unit starts the transmission of CAN communication with the sleep wake up signal. In addition, the combination meter transmits the wake up signal to BCM via CAN communication to report the CAN communication start.
WAKE-UP OPERATION CHART
| Wake-up condition |
| BCM wake-up condition |
CAN wake-up condition |
- Door unlock sensor: OFF→ON, ON→OFF
- Door lock assembly LH (key cylinder switch): Lock or unlock
- Door lock switch: OFF→ON
- Door unlock switch: OFF→ON
- Trunk lid opener switch: OFF→ON
- Power window serial link communication: Receiving
- Remote keyless entry receiver: Receiving valid keyfob
|
- Receiving the sleep-ready signal (Not-ready) from any units
- Key slot: OFF→ON, ON→OFF
- Push-button ignition switch (push switch): OFF→ON
- Hazard switch: OFF→ON
- PASSING switch: OFF→ON, ON→OFF
- TAIL LAMP switch: OFF→ON
- Driver door switch: OFF→ON, ON→OFF
- Passenger door switch: OFF → ON, ON → OFF
- Trunk room lamp switch: OFF→ON, ON→OFF
- Driver door request switch: OFF→ON
- Passenger door request switch: OFF→ON
- Trunk request switch: OFF→ON
- Stop lamp switch 2 signal: ON
- Remote keyless entry receiver: Receiving valid keyfob
|