Front Power Window Motor LH Circuit Check

WARNING: This page is about a different car, the 2004 Nissan Titan. However, it is still accessible from the selected car via links, so may be relevant.

CHECK MAIN POWER WINDOW AND DOOR LOCK/UNLOCK SWITCH OUTPUT SIGNAL

Turn ignition switch ON.
Check voltage between main power window and door lock/unlock switch connector D7 terminal 8, 11 and ground.

CONNECTOR TERMINAL VOLTAGE CONDITION

Connector	Terminals (Wire color)		Condition	Voltage (V) (Approx.)
Connector	(+)	(-)	Condition	Voltage (V) (Approx.)
D7	8 (G/R)	Ground	UP	Battery voltage
	8 (G/R)		DOWN	0
	11 (G/W)		UP	0
	11 (G/W)		DOWN	Battery voltage

Fig 1: Checking Voltage Between Main Power Window And Door Lock/Unlock Switch And Ground

Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG

OK: GO TO 2.
NG: Replace main power window and door lock/unlock switch.

CHECK POWER WINDOW MOTOR CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect main power window and door lock/unlock switch and front power window motor LH.
3. Check continuity between main power window and door lock/unlock switch connector D7 terminal 8, 11 and front power window motor LH connector D9 terminal 1, 2.
  8 (G/R) - 2 (G/R): Continuity should exist.
  
  11 (G/W) - 1 (G/W): Continuity should exist.
OK or NG
1. OK: Replace front power window motor LH.
2. NG: Repair or replace harness.
Fig 2: Checking Continuity Between Main Power Window And Front Power Window Motor Connector
Courtesy of NISSAN MOTOR CO., U.S.A.