Ultrasonic Sensor: Installation

INSTALL NO. 1 ULTRASONIC SENSOR
1. Install the sensor to the rear bumper.
2. Install the sensor retainer as shown in the illustration.
3. Connect the sensor connector.
  
  Fig 1: Installing No 1 Ultrasonic Sensor
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL NO. 2 ULTRASONIC SENSOR
1. Install the sensor to the rear bumper.
2. Install the sensor retainer as shown in the illustration.
3. Connect the sensor connector.
  
  Fig 2: Installing No 2 Ultrasonic Sensor
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL REAR BUMPER COVER (See INSTALLATION )
INSTALL REAR NO. 1 BUMPER PLATE (See INSTALLATION )
INSTALL NO. 3 ULTRASONIC SENSOR
1. Install the sensor retainer to the front bumper.
  
  Fig 3: Installing No 3 Ultrasonic Sensor Retainer
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the sensor as shown in the illustration.
3. Connect the sensor connector.
  
  Fig 4: Installing No 3 Ultrasonic Sensor
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT BUMPER COVER (See INSTALLATION )
INSTALL FRONT FENDER LINER LH (See INSTALLATION )
INSTALL FRONT FENDER LINER RH (See INSTALLATION )
INSTALL ENGINE UNDER COVER (See INSTALLATION )
INSTALL COOL AIR INTAKE DUCT SEAL (See INSTALLATION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
PERFORM INITIALIZATION
1. Perform initialization (see INITIALIZATION (2006/02-2006/07) ).
  NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.