Terminals Of Ecu

CHECK TELEVISION CAMERA ASSEMBLY

Fig 1: Identifying Television Camera Connector Terminals

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Measure the voltage and resistance between each terminal of the wire harness side connector.

VOLTAGE AND RESISTANCE SPECIFICATION

Symbols (Terminal No.)	Wiring Color	Terminal Description	Condition	Specified Condition
CGND (Y8-3) - Body ground	W - Body ground	Ground	Always	Below 1 Ω
CB+ (Y8-4) - CGND (Y8-3)	B - W	Power source	Power switch ON (IG), shift lever R position	Approx. 6 V

If the result is not as specified, there may be a malfunction on the wire harness side.

Measure the voltage and frequency between each terminal of the connector.

VOLTAGE AND FREQUENCY SPECIFICATION

Symbols (Terminal No.)	Wiring Color	Terminal Description	Condition	Specified Condition
CV+ (Y8-2) - CV - (Y8-1)	R - Shielded	Display signal	Power switch ON (IG), shift lever R position	See WAVEFORM 1

If the result is not as specified, the camera may have a malfunction.

Using an oscilloscope, check the waveform.

Waveform 1

WAVEFORM REFERENCE (WAVEFORM 1)

Item	Content
Symbols (Terminal No.)	CV+ (Y8-2) - CV- (Y8-1)
Tool Setting	0.2 V/DIV., 0.2 μsec/DIV.
Condition	Power switch ON (IG), shift lever in R position

Fig 2: Waveform 1 Graph