LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2007 >> GS 450h >> Repair and Diagnosis >> Accessories & Equipment >> Entertainment Systems >> Audio/Visual >> Radio Receiver >> Removal
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Radio Receiver: Removal

  1. SET RADIO RECEIVER ASSEMBLY TO SHIPMENT MODE 
    1. Remove all discs and tape.
      NOTE: If the discs or tape cannot be removed, do not attempt to remove them forcibly. Send the unit to a repair shop.
    2. Turn the power switch OFF.
    3. While simultaneously pressing the "SEEK UP" and "DISC" switches, turn the power switch ON (ACC).
      Fig 1: Identifying "DISC" Switches And Power Switch
      G05311462Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      HINT:

      The CD loading door indicator light blinks during mode setting and it remains lit after the setting is completed.

      Fig 2: Identifying CD Loading Door Indicator Light
      G05300354Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Turn the power switch OFF.
  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
  3. REMOVE FRONT CONSOLE UPPER PANEL GARNISH  (See REMOVAL )
  4. REMOVE CONSOLE UPPER PANEL ASSEMBLY  (See REMOVAL )
  5. REMOVE INSTRUMENT PANEL FINISH PANEL END LH  (See REMOVAL )
  6. REMOVE INSTRUMENT PANEL FINISH PANEL END RH  (See REMOVAL )
  7. REMOVE MULTI-DISPLAY WITH RADIO RECEIVER ASSEMBLY 
    1. Remove the 4 bolts.
      Fig 3: Locating Multi-Display With Radio Receiver Bolts
      G05299587Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Pull the multi-display with radio receiver to detach the 2 clips on the backside of the multi-display.
    3. Disconnect the connectors and remove the multi-display with radio receiver.
      Fig 4: Pulling Multi-Display With Radio Receiver
      G05299588Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  8. CONFIRM RADIO RECEIVER ASSEMBLY SHIPMENT MODE SETTING 
    1. Look at the backside of the radio receiver and check that a metal plate can be seen through the hole near the "SHIP" mark.
      NOTE: If a metal plate cannot be seen, perform the shipment mode setting again.
      Fig 5: Identifying "SHIP" Mark
      G05299589Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  9. REMOVE NO. 2 RADIO BRACKET 
    1. Remove the 5 bolts and bracket.
      Fig 6: Locating No. 2 Radio Bracket Bolts
      G05299590Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  10. REMOVE NO. 1 RADIO BRACKET 
    1. Remove the 5 bolts and bracket.
      Fig 7: Locating No. 1 Radio Bracket Bolts
      G05299591Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals