LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2007 >> GS 350 AWD >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Engine Immobilizer >> Engine Immobiliser System >> Certification ECU Power Source Circuit >> Inspection Procedure
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Inspection Procedure

  1. INSPECT FUSE (SECURITY) 
    1. Remove the SECURITY fuse from the cowl side junction block RH.
    2. Measure the resistance of the fuse.

      Standard resistance: 

      Below 1 Ω 

    NG: REPLACE FUSE 

    OK: Go to next step 

  2. CHECK WIRE HARNESS (CERTIFICATION ECU - BATTERY AND BODY GROUND) 
    1. Disconnect the U28 ECU connector.
    2. Measure the resistance and voltage of the wire harness side connector.

      Standard resistance 

      TESTER CONNECTION SPECIFIED CONDITION CHART

      Tester Connection Specified Condition
      U28-17 (E) - Body ground Below 1 Ω

      Standard voltage 

      TESTER CONNECTION SPECIFIED CONDITION CHART

      Tester Connection Specified Condition
      U28-1 (+B1) - Body ground 10 to 14 V
    Fig 1: Identifying U28 ECU Connector Terminal
    G05298618Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

    NG: REPAIR OR REPLACE HARNESS AND CONNECTOR 

    OK: REPLACE CERTIFICATION ECU 

scientia non olet · About LEMON Manuals