Inspection Procedure

WARNING: This page is about a different car, the 2007 Toyota Camry. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

After the inspection is completed, clear the DTCs.

CHECK VEHICLE SENSOR (NAVIGATION CHECK MODE)
1. Enter the "Navigation Check" mode (Vehicle Sensors) (See NAVIGATION CHECK MODE ).
  
  Fig 1: Diagnosis MENU Screen Display - Navigation Check Mode
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. While driving the vehicle, compare the "SPD" indicator to the reading on the speedometer. Check if these readings are almost equal.
  OK: The readings are almost equal.
OK: REPLACE RADIO AND NAVIGATION ASSEMBLY

NG: Go to Next Step
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
Refer to "Speed signal does not change in the navigation check mode" in PROBLEM SYMPTOMS TABLE .

NEXT: END