LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2006 >> IS 350 >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Engine Control System (2GR-FSE) >> Crankshaft Position Sensor >> Removal
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Crankshaft Position Sensor: Removal

  1. REMOVE COOL AIR INTAKE DUCT SEAL (See  REMOVAL  ) 
  2. REMOVE V-BANK COVER SUB-ASSEMBLY (See  REMOVAL  ) 
  3. REMOVE NO. 1 INLET AIR CLEANER (See  REMOVAL  ) 
  4. DISCHARGE REFRIGERANT FROM REFRIGERATION SYSTEM (See  REMOVAL  ) 
  5. REMOVE V-RIBBED BELT (See  REMOVAL  ) 
  6. REMOVE ENGINE UNDER COVER 
  7. REMOVE REAR ENGINE UNDER COVER LH 
  8. DISCONNECT NO. 1 COOLER REFRIGERANT SUCTION HOSE (See  REMOVAL  ) 
  9. DISCONNECT DISCHARGE HOSE SUB-ASSEMBLY (See  REMOVAL  ) 
  10. REMOVE COMPRESSOR WITH PULLEY ASSEMBLY (See  REMOVAL  ) 
  11. REMOVE CRANKSHAFT POSITION SENSOR 
    1. Disconnect the crankshaft position sensor connector.
    2. Remove the bolt and crankshaft position sensor.
      Fig 1: Identifying Crankshaft Position Sensor
      G04054943Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals