Center Airbag Sensor Assembly: Installation

WARNING: This page is about a different car, the 2006 Lexus GS 300. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL CENTER AIRBAG SENSOR ASSEMBLY
1. Check that the engine switch is off.
2. Check that the battery negative (-) terminal is disconnected.
  NOTE: After disconnecting the negative battery terminal, wait for at least 90 seconds before starting the operation.
3. Install the center airbag sensor with the nut and 2 bolts.
  Torque: 18 N*m (184 kgf*cm, 13 ft.*lbf)
  NOTE:
  - If the center airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.
  - When installing the center airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.
4. Check that there is no looseness in the installation parts of the center airbag sensor.
5. Connect the holder (with connectors).
6. Check that the water-proof sheet is properly set.
  
  Fig 1: Identifying Center Airbag Sensor Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL CONSOLE BOX (See INSTALLATION )
INSTALL CONSOLE BOX REGISTER ASSEMBLY (See INSTALLATION )
INSTALL CONSOLE BOX PLATE (See INSTALLATION )
INSTALL INSTRUMENT PANEL FINISH PANEL LH END (See INSTALLATION )
INSTALL INSTRUMENT PANEL FINISH PANEL RH END (See INSTALLATION )
INSTALL FRONT ASH RECEPTACLE ASSEMBLY (See INSTALLATION )
INSTALL CONSOLE UPPER PANEL GARNISH FRONT (See INSTALLATION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
PERFORM INITIALIZATION
INSPECT SRS WARNING LIGHT