Inspection Procedure

1. Measure the voltage of the battery.

   Standard voltage: 

   11 to 14 V 

NG: REPLACE BATTERY 

OK: Go to next step 

1. Check the ECU-B fuse.

   Standard resistance: 

   Below 1 Ω 

NG: REPLACE FUSE 

OK: Go to next step 

1. Turn the ignition switch to the LOCK position.
2. Disconnect the negative (-) terminal cable from the battery, and wait for at least 90 seconds.
3. Disconnect the connector from the occupant classification ECU.
4. Connect the negative (-) terminal cable to the battery.
5. Turn the ignition switch to the ON position.
6. Measure the voltage according to the value(s) in the table below.
   Fig 1: Checking Wire Harness

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Standard voltage 

   STANDARD VOLTAGE
   
   

   Tester connection	Condition	Specified condition
   O3-1 (+B) - Body ground	Always	10 to 14 V
   O3-7 (IG) - Body ground	Ignition switch ON	10 to 14 V

7. Turn the ignition switch to the LOCK position.
8. Measure the resistance according to the value(s) in the table below.

   Standard resistance 

   STANDARD RESISTANCE
   
   

   Tester connection	Condition	Specified condition
   O3-3 (GND) - Body ground	Always	Below 1 Ω

NG: REPAIR OR REPLACE WIRE HARNESS 

OK: Go to next step 

1. Turn the ignition switch to the ON position.
2. Clear the DTCs stored in the occupant classification ECU (See DTC CHECK / CLEAR  ).
3. Clear the DTCs stored in the center airbag sensor assembly (See DTC CHECK / CLEAR  ).
4. Turn the ignition switch to the LOCK position.
5. Turn the ignition switch to the ON position, and wait for at least 10 seconds.
6. Check the DTCs (See DTC CHECK / CLEAR  ).

   OK: 

   DTC B1794 is not output. 

   HINT:

   Codes other than code B1794 may be output at this time, but they are not related to this check.

OK: USE SIMULATION METHOD TO CHECK 

NG: Go to next step 

1. Turn the ignition switch to the LOCK position.
2. Disconnect the negative (-) terminal cable from the battery, and wait for at least 90 seconds.
3. Replace the occupant classification ECU (See REMOVAL  ).

1. Connect the negative (-) terminal cable to the battery.
2. Connect the intelligent tester to the DLC3.
3. Turn the ignition switch to the ON position.
4. Using the intelligent tester, perform the "Zero point calibration" (See INITIALIZATION  ).

   OK: 

   The "COMPLETED" is displayed. 

1. Using the intelligent tester, perform the "Sensitivity check" (See INITIALIZATION  ).

   Standard value: 

   27 to 33 kg (59.52 to 72.75 lb) 

NEXT: END