LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2004 >> IS 300 Base, Automatic >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Servicing - A/T >> Removal & Installation >> O/D Direct Clutch Speed Sensor >> On-Vehicle Repair
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

On-Vehicle Repair

  1. REMOVE NO. 1 AND NO. 2 ENGINE UNDER COVERS 
  2. REMOVE LH FRONT FLOOR CENTER COVER 
  3. REMOVE NO. 1 REAR FLOOR BOARD 
  4. DISCONNECT O/D DIRECT CLUTCH SPEED SENSOR CONNECTOR 
  5. REMOVE O/D DIRECT CLUTCH SPEED SENSOR 
    1. Remove the bolt and O/D direct clutch speed sensor.
    2. Remove the O-ring from the O/D direct clutch speed sensor.
  6. INSTALL O/D DIRECT CLUTCH SPEED SENSOR 
    1. Coat a new O-ring with ATF and install it to the O/D direct clutch speed sensor.
    2. Install the O/D direct clutch speed sensor to the transmission case and torque the bolt.

      Torque: 5.4 N.m (55 kgf.cm, 48 in.lbf) 

  7. INSTALL NO. 1 REAR FLOOR BOARD 
  8. INSTALL LH FRONT FLOOR CENTER COVER 
  9. INSTALL NO. 1 AND NO. 2 ENGINE UNDER COVERS 
    Fig 1: Disconnecting O/D Direct Clutch Speed Sensor Connector
    G01314523Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals