ECM Power Source Circuit
CIRCUIT DESCRIPTIONWhen the ignition switch is turned ON, the positive battery voltage is applied to terminal IGSW of the ECM and the EFI relay (Marked: EFI) control circuit in the ECM sends a signal to terminal MREL of the ECM switching on the EFI relay.
This signal causes current to flow to the coil, closing the contacts of the EFI relay and supplying power to terminal +B of the ECM.
If the ignition switch is turned OFF, the ECM holds the EFI relay for a maximum of 2 seconds to allow for the initial setting of the throttle valve.
Wiring Diagram:
Step 1 - 3:
Step 4 - 6:
Step 7 - 8:
Step 9:
INSPECTION PROCEDURE